NUTMEG SERIAL VIDEO PROJECTOR CONTROL CARD



NUTMEG SERIAL VIDEO PROJECTOR CONTROL CARD and panels

For the new generation of Barco and Sony serially controlled video/data projectors, this card offers total control under SPICE Automation. Using one card for each compatible projector in your system, you will be able to switch the projector fan on and off; select a composite video picture source from the eight different composite video sources input to the Video Input Monitor Card; fade the image (using the same fade curve used for incandescent projectors in SPICE Automation); and adjust the contrast (crucial for maintaining true black backgrounds in special effects sequences).

SPECIFICATIONS

INPUT/OUTPUT CONNECTIONS

VIDEO OUT - Single composite video output via BNC. Will drive 75 O Ohm cable 100 ft.
LOCAL VIDEO IN - Single composite video input via BNC. 75 Ohm terminated.
PROJECTOR CONTROL - 25 pin Dshell connector, modified RS232 pinout.

PANEL CONTROLS

BUS VIDEO/LOCAL VIDEO - Switch connects the output of the card to either the LOCAL VIDEO IN or the internal NUTMEG video bus.

GENERAL CAPABILITIES

Controls the Brightness and Contrast of the Projected images via SPICE AUTOMATION. Selects source to the projector via the internal NUTMEG bus or the LOCAL VIDEO IN connector.

DEVICES CURRENTLY SUPPORTED

SONY VPH-1271, 1272, 1251, 1252 and comparable units.
BARCO BARCOVISION 1100, 1101, 700, 701, and comparable units.

MAXIMUM CABLE RUN

100 ft nominal, see NUTMEG VIDEO INPUT CARD specifications for more details.

POWER REQUIREMENTS

Card draws necessary power directly from the NUTMEG
Card requires one open option-card slot in a NUTMEG

SS 276-114 NUTMEG Serial Video Projector Control Card