NUTMEG 12 CHANNEL PHASE DIM CARD
   |
The ultimate in inexpensive control for triac dimmers! Provides twelve "pull to ground" phase dim outputs for driving remote triac dimmers or silicon switches. Each channel is programmable using SPICE Automation. The 12 Channel Phase Dim card operates with SS 4551 & SS 4553 low voltage dimmers and available solid state relays. Optional Console Tally Rider Card provides feedback to illuminated console pushbuttons. Sophisticated manual control function is available. |
SPECIFICATIONS
INPUT/OUTPUT CONNECTIONS
CHANNEL OUTPUTS - 25 pin Dshell female. Twelve "pull to ground" phase dim outputs, twelve phase reference inputs, and one ground.
GND - 1/4" faston connector to allow a strong ground connection.
CHANNEL INPUTS - 25 pin Dshell male. Twelve switch inputs, twelve 0-12 VDC inputs, and one ground.
PANEL DISPLAYS
12 red status leds, one for each output.
GENERAL CAPABILITIES
Utility card for control of lamps via a remote triac or silicon switch.
MAXIMUM CABLE RUN
100 ft nominal.
POWER REQUIREMENTS
Card draws necessary power directly from the NUTMEG
Power must be supplied for the load dependent on application.
Card requires one open option-card slot in a NUTMEG
When ordered with OPTIONAL CONSOLE TALLY RIDER CARD the following ADDITIONAL SPECIFICATIONS apply—
INPUT/OUTPUT CONNECTIONS
LAMP TALLY OUTPUTS - 25 pin Dshell female. 24 bilevel lamp drive outputs to control lighted pushbutton switches.
SYSTEM CONTROLS - 9 pin Dshell male. Eight switch inputs and one ground.
GND/CON LO/CON HI - 3 pin detachable terminal strip. Provides the voltages for the bilevel lamp control.
GENERAL CAPABILITIES
Attaches to any of the Utility cards for control of backlighted switches and for system controls such as Auto/Manual selection, all outputs set and all outputs reset.
SS 276-136 NUTMEG 12 Channel Phase Dim Card
SS 276-137 with optional Console Tally Rider Card
SS 276-138 without manual controls