NUTMEG 12 CHANNEL DC VARIABLE CARD
   |
A cost-effective way to furnish variable DC voltages to devices such as lamp dimmers, slews, zooms, etc. Provides twelve channels of up to 12VDC, each channel is individually configurable to a specific volt range and programmable using SPICE Automation. Optional Console Tally Rider Card provides feedback to illuminated console pushbuttons. Sophisticated manual control function is available. |
SPECIFICATIONS
INPUT/OUTPUT CONNECTIONS
CHANNEL OUTPUTS - 15 pin Dshell female. Twelve 0-12 VDC outputs and one ground.
CHANNEL INPUTS - 25 pin Dshell male. Twelve switch inputs, twelve 0-12 VDC inputs, and one ground.
PANEL DISPLAYS
12 red status leds, one for each output.
GENERAL CAPABILITIES
Utility card used where DC low level sources are needed with loads under 5 milliamps. Common uses are control of dimmer paks, slews, zooms, etc.
MAXIMUM CABLE RUN
Dependent on load, 25 ft nominal.
POWER REQUIREMENTS
Card draws necessary power directly from the NUTMEG
Card requires one open option-card slot in a NUTMEG
When ordered with OPTIONAL CONSOLE TALLY RIDER CARD the following ADDITIONAL SPECIFICATIONS apply—
INPUT/OUTPUT CONNECTIONS
LAMP TALLY OUTPUTS - 25 pin Dshell female. 24 bilevel lamp drive outputs to control lighted pushbutton switches.
SYSTEM CONTROLS - 9 pin Dshell male. Eight switch inputs and one ground.
GND/CON LO/CON HI - 3 pin detachable terminal strip. Provides the voltages for the bilevel lamp control.
GENERAL CAPABILITIES
Attaches to any of the Utility cards for control of backlighted switches and for system controls such as Auto/Manual selection, all outputs set, and all outputs reset.
SS 276-126 NUTMEG 12 Channel DC Variable Card
SS 276-127 with optional Console Tally Rider Card
SS 276-128 without manual controls